Description
The Victron ARG100201020 is a FET battery isolator for systems with two battery banks. It lets one alternator or a single-output battery charger charge both banks at the same time, while the banks stay electrically separated during discharge. That separation helps keep accessory loads from draining the starter battery. The unit is rated for 100A maximum charge current.
Features
- Charges two battery banks from one alternator or a single-output battery charger
- Maximum charge current 100A and maximum alternator current 100A
- FET isolation instead of diode isolation, with less than 0.02V voltage drop at low current
- Average voltage drop of approx. 0.1V at higher currents
- Victron says no alternator voltage increase is normally needed to offset isolator losses
- Alternator energize input for alternators that need DC voltage at B+ before they charge
- Keeps the battery banks isolated during discharge, so accessory loads are less likely to drain the starter battery
- M8 bolt main connections
Specifications
| Manufacturer | Victron Energy |
| Model | Argo FET Battery Isolator 100-2 |
| Part number | ARG100201020 |
| Product type | FET Battery Isolator |
| Number of batteries | 2 |
| Maximum charge current | 100A |
| Maximum alternator current | 100A |
| Isolation technology | FET |
| Voltage drop at low current | Less than 0.02V |
| Average voltage drop at higher current | Approx. 0.1V |
| Alternator energize input | Yes |
| Main connections | M8 bolts |
| Dimensions (H × W × D) | 2.6 × 4.7 × 7.9 in |
| Weight | 3.1 lb |
Compatibility
The Victron ARG100201020 is listed for use with a compatible single-output battery charger and with compatible alternators that need DC voltage at B+ to start charging. Listed uses include starter and auxiliary battery systems, vehicle dual-battery systems, marine battery systems and RV and mobile power systems. Confirm your system matches these before you buy.










