Description
The Dickinson Antarctic diesel heater, part 00-ANT, is a compact diesel heater designed for floor mounting. It gives comfortable, dry heat and is built from laser-cut 304 stainless steel. Dickinson describes it as small and budget-friendly, and it is offered with either a one-turn or a two-turn hot water coil option.
Features
- Produces dry heat to eliminate moisture inside the vessel.
- Laser-cut design in 304 stainless steel.
- Includes a 12v fan for start-up and draft assistance. Dickinson says the fan can be converted to 24v if requested when ordering.
- Valve is factory set for #2 diesel; valves for kerosene and #1 diesel are also available.
- Hot water coil options: a 1-turn coil can heat 5-10 gallons of water, and a 2-turn coil can heat 15-20 gallons.
- Requires 3” diameter chimney parts and a permanent fresh air vent in the unit’s area.
- For chimneys 6ft or longer, a barometric damper is highly recommended.
- Sailboat installation: must face fore or aft. For port or starboard facing, mount the valve on the side, especially on heels up to 15 degrees.
Specifications
| Part number | 00-ANT |
| Width | 13″ |
| Height | 25″ |
| Depth | 14″ |
| Weight | 27 lbs. |
| Heat output, low | 6500 BTU |
| Heat output, high | 16250 BTU |
| Fuel consumption (24hr), low | 1.29 gal |
| Fuel consumption (24hr), high | 3.20 gal |
| Chimney parts | 3” diameter |
| Chimney length | Minimum 4ft, ideal 6ft with no elbows, maximum 8ft |
| Draft assist fan | 12v |
| Factory fuel setting | #2 diesel |
| Hot water coil options | 1-turn (heats 5-10 gallons of water) or 2-turn (heats 15-20 gallons) |








