Description
The Victron Smart BatteryProtect 12/24V-220A (part BPR122022000) is a battery protection device that disconnects non-essential loads before the battery is drained far enough to be damaged, or too low to start the engine. Its levels can be set over Bluetooth or with a programming pin.
Features
- Cuts non-essential loads before the battery is over-discharged, and keeps enough power to start the engine.
- Bluetooth programming sets the engage and disengage levels, or one of nine predefined levels can be chosen with the programming pin.
- Bluetooth can be disabled if it is not needed.
- Detects 12/24V system voltage automatically during initial setup.
- Li-ion setting for lithium batteries, and it can act as a charge interrupter between a charger and a Li-ion battery.
- Disconnects the load when voltage exceeds 16.3V or 32.6V, to protect sensitive electronics.
- Uses MOSFET switching instead of relays.
- Disconnects the load 90 seconds after voltage drops below the threshold, and reconnects it 30 seconds after voltage rises above it.
Specifications
| Part number | BPR122022000 |
| Model | Smart BatteryProtect 12/24V-220A |
| Brand | Victron Energy |
| Current rating | 220A |
| System voltage | 12/24V, auto ranging |
| Voltage range | 6-35 VDC |
| Over-voltage disconnect | 16.3V or 32.6V |
| Load disconnect delay | 90 seconds |
| Load reconnect delay | 30 seconds |
| Alarm delay | 12 seconds of undervoltage |
| Alarm output | Open collector, max 50 mA |
| Switching | MOSFET |
| Bluetooth | Yes, can be disabled |
| Predefined levels | Nine, set with the programming pin |
| Lithium setting | Li-ion mode |
| Current flow | IN to OUT only; connect the battery to IN for load protection |
What’s included
One Smart BatteryProtect 12/24V-220A cut-off device is listed as included.
Compatibility
- The Li-ion mode is controlled by the VE.Bus BMS for charge and discharge control.
- The alarm output can activate LEDs, buzzers or relays.






