Description
The Victron BMS400100000 SmallBMS is a simple, low-cost alternative to the VE.Bus BMS, meant for Victron Smart LiFePO4 batteries that use M8 round connectors. In several applications it can take the place of the VE.Bus BMS, but it has no VE.Bus interface, so it is not suitable for VE.Bus MultiPlus and Quattro inverter/chargers. It protects 12V, 24V and 48V systems and has three outputs.
Features
- Three outputs, similar to the VE.Bus BMS: Load Disconnect, Pre-alarm and Charge disconnect.
- Load output: 1A maximum and not short-circuit protected; it can control a high current relay or contactor.
- Pre-alarm output: 1A maximum (not short circuit protected), with a minimum delay of 30 seconds before load disconnect.
- Charge disconnect output: 10mA maximum; not suitable to power an inductive load such as a relay coil.
- System on/off input (Remote L and Remote H) controls both outputs; when off, loads and chargers are turned off.
- Blue Load ON LED shows the load output is high; red Temp or OVP LED shows the charger output is free floating due to cell over temperature (>50°C) or cell over voltage.
Specifications
| Brand | Victron Energy |
| Manufacturer Part Number | BMS400100000 |
| UPC | 8719076043485 |
| Operating voltage range | 8 to 70V DC |
| Systems protected | 12V, 24V and 48V |
| Load output maximum current | 1A |
| Load output default cell under voltage | 2,8V/cell, adjustable on the battery between 2,6V and 2,8V per cell |
| Pre-alarm maximum current | 1A (not short circuit protected) |
| Pre-alarm default cell under voltage | 3,1V/cell, adjustable on the battery between 2,85V and 3,15V per cell |
| Minimum delay, pre-alarm to load disconnect | 30 seconds |
| Charge disconnect output maximum current | 10mA |
| Battery connector type | M8 circular connectors |
| System on/off terminals | Remote L and Remote H |
| Weight | 0.3 lb |
Compatibility
- Intended for Victron Smart LiFePO4 batteries fitted with M8 circular connectors.
- The Victron BMS400100000 is not suitable for use with VE.Bus MultiPlus and Quattro inverter/chargers, because it has no VE.Bus interface.






