Description
The NAC-D Autopilot Computer is a steer-by-wire autopilot solution for Electronic Vessel Control Systems, which are steering systems with a digital interface. It connects with two Micro-C connectors and needs no extra hydraulic pump, rudder sensor or dockside rudder calibration. It is controlled from an AP 44 or AP 48 controller and works with SeaStar Solutions, Volvo, Yanmar and Yamaha control systems.
Features
- Steer-by-wire design: the steering signal between autopilot and actuator, pump or rudder travels as a digital communication protocol
- Approved control system interface for SeaStar Solutions, Volvo, Yanmar and Yamaha systems
- Needs only two Micro-C connectors, with no extra hydraulic pump, rudder sensor or dockside calibration
- Switches automatically between two speed profiles for steering at both low and high speeds
- Continuum steering with SteadySteer, so you can take manual control through turns without disengaging the autopilot
- Steers to a waypoint, heading or set turn pattern, including a U-turn, spiral turn and zigzag turn
- CAN-bus data connection to Optimus steering systems
Specifications
| Part number | 000-15621-001 |
| UPC | 9420064115747 |
| Type | Steer-by-wire autopilot computer |
| Controllers | AP 44 or AP 48 |
| Connections | Two Micro-C connectors |
| Compass sensor support | NMEA 2000 |
| Drive output | EVC |
| Engine drive systems integration | Volvo EVC, Yamaha, Yanmar, Optimus |
| Turn patterns | C-turn, U-turn, Zigzag turn, Square turn, S-turn, Depth counter tracking (DCT) |
| Warranty period | 2 years |
What’s in the box
- N2K-T-RD Network T-Connector
Control Systems
For boaters with SeaStar Optimus, Yanmar VC10/JC10, Volvo IPS/EVC or Yamaha helm master or single engine control systems.






