Description
The Alaska Diesel Heater, model 00-ALA-12-1T from Dickinson Marine, is a compact diesel heater designed for floor mounting. This version adds a one-turn hot water coil that can heat 5-10 gallons of water. Dickinson Marine describes the heater as giving comfortable, dry heat, and the page also gives sailboat installation notes.
Features
- Compact floor-mounted diesel heater that produces dry heat to remove moisture inside the vessel.
- Laser-cut design in 304 stainless steel.
- Includes a 12v fan for start-up and draft assistance.
- One-turn hot water coil, which can heat 5-10 gallons of water.
- Valve factory set for #2 diesel; valves for kerosene and #1 diesel are also available.
- On sailboats, face the heater fore or aft. For port or starboard facing, mount the valve on the side for proper fuel flow at heels up to 15 degrees.
Specifications
| Part number | 00-ALA-12-1T |
| UPC | 814901012341 |
| Heat output, low | 6500 BTU |
| Heat output, high | 16250 BTU |
| Fuel consumption (24hr), low | 1.29 gal |
| Fuel consumption (24hr), high | 3.20 gal |
| Hot water coil | 1-turn, heats 5-10 gallons of water |
| Factory fuel setting | #2 diesel |
| Fan | 12v |
| Chimney diameter | 3” diameter |
| Chimney length | minimum 4ft, maximum 8ft |
| Width | 8.75” |
| Height | 20.75” |
| Depth | 9.5” |
| Weight | 19 lbs. |
| Material | 304 stainless steel |
Installation requirements
- Chimney parts must be 3” diameter.
- Chimney run must be at least 4ft and no more than 8ft; a straight run with no elbows works best.
- Dickinson Marine recommends a barometric damper for chimneys 6ft or longer.
- The area around the heater needs a permanent fresh air vent.
Dickinson Marine lists a Diesel Heater Installation & Operating Manual and an Alaska Information Sheet for this heater. It says to follow the installation guidelines for optimal performance.









