Description
The Victron BMV-700 Battery Monitor (BAM010700000) measures the current moving into and out of a battery bank and works out its state of charge. It shows volts, amps, amp hours and time to go for one battery bank, and it keeps historic data such as the number of cycles and the deepest discharge. A 500 A / 50 mV shunt is included, and the monitor is designed for flush-mount installation.
Features
- Monitors volts, amps, amp hours and time to go for a single battery bank.
- Reads state of charge as percentage remaining and as amp hours remaining.
- Shunt rated 500 A / 50 mV, included with the monitor.
- Supply voltage range of 6.5 to 95 VDC.
- Programmable visual and audible alarms.
- The bezel can be removed to suit a round or square display face.
- Keeps historic data, including battery efficiency, average and deepest discharge, number of cycles, and overvoltage and undervoltage alarms.
- VE.Direct communication port, and a relay rated 60V/1A normally open (function can be inverted).
Specifications
| Model | BMV-700 |
| Part number | BAM010700000 |
| Supply voltage range | 6.5 to 95 VDC |
| Battery capacity | up to 9999 Ah |
| Shunt | 500 A / 50 mV |
| Current draw, backlight off | < 4 mA |
| Relay | 60V/1A normally open (function can be inverted) |
| VE.Direct communication port | Yes |
| Installation | Flush mount |
| Front bezel | 69 x 69 mm (2.7 x 2.7 inch) |
| Front face diameter | 63 mm |
| Body diameter | 52 mm (2.0 inch) |
| Body depth | 31 mm (1.2 inch) |
| Operating temperature range | -20 to +50°C (0 to 120°F) |
| Cable | 10 m, 6 core UTP with RJ12 connectors |
What’s included
- Meter body
- Retaining nut for mounting the meter when there is access from behind
- Face plate, mounting screws and snap-on bezel for mounting when there is no access from behind
- Shunt with circuit board
- 10 m interconnecting cable with RJ12 plug ends
- One power cable with fuse
- Instruction manual
- Quick install sheet
Not included: a length of battery cable to run between the shunt and the battery.






