Description
Stabond U148ECO replaces the 2 Part UK-148 Adhesive.
STABOND U148ECO is a high-solids, low-VOC, brushable, single component elastomeric contact adhesive which provides high strength bonds to many plastics and synthetic rubbers such as SBR, Neoprene, Nitrile, PVC, ABS, rigid urethane foam, and Hypalon.
Application: Stabond U-148 ECO is formulated for brush application. Surfaces to be bonded must be free of dirt, oil, and grease. Clean the substrate
with a solvent such as acetone or MEK. Lightly abrading the substrate will improve the bond. Apply a thin uniform film to each substrate
and allow 5-10 minutes for the solvent to flash off. Apply sufficient pressure to insure intimate contact. Immediate bond strength
permits handling and ultimate adhesion develops within 24 hours.
Properties:
TYPE: SYNTHETIC ELASTOMER
CURE TIME: 48 HOURS
APPEARANCE: CLEAR LIQUID
PEEL STRENGTH: ≥ 8 PIW
SOLIDS: 28%
THINNER: STABOND C THINNER
SHELF LIFE: 1 YEAR
FLASH POINT: 28°F
WT/GAL: 7.2 LBS
VISCOSITY: 1500 CPS
Storage: For maximum shelf life, store material in a cool, dry area and keep container tightly sealed. Storage temperatures of 60-80°F are
recommended. Lower storage temperature will cause a temporary increase in viscosity.
