Description
The Airmar MM1-DST-10F is an 8m Mix and Match adapter cable with a Furuno 10-pin connector. It is the brand-specific part of a Mix and Match 1kW transducer setup. The transducer carries a short 2m cable ending in an Airmar 9-pin male connector, and this adapter has the matching 9-pin female connector at one end. Both parts are needed for an installation.
Features
- 8m adapter cable, longer than the 2m cable attached to the transducer
- Airmar 9-pin female connector at one end, Furuno 10-pin connector at the other
- Interchangeable: if you change electronics brand later, keep the transducer and replace only the adapter cable
- Designed for 1kW Mix and Match transducers
Specifications
| Part number | MM1-DST-10F |
| Brand | Airmar |
| Product type | Mix and Match adapter cable |
| Length | 8m |
| Transducer end connector | Airmar 9-pin female |
| Electronics end connector | Furuno 10-pin |
| Transducer type | 1kW Mix and Match |
Transducer Requirements
This cable is for 1kW Mix and Match transducers. It cannot be used with 600W transducers or CHIRP transducers. Both this adapter cable and the transducer’s short 2m cable are needed for an installation.
Warning
WARNING: This product can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information go to P65Warnings.ca.gov.







