Description
The Victron Energy BPR000065400 BatteryProtect is a 12/24V low-voltage disconnect that cuts power to non-essential loads before a battery is fully discharged. It has a 65A maximum continuous load current and an operating voltage range of 6-35V. Victron describes it as ignition proof because it switches with MOSFETs instead of relays.
Features
- Disconnects non-essential loads before the battery is fully discharged or too weak to crank the engine.
- Detects the 12V or 24V system voltage automatically.
- Engage and disengage voltages can be set at several levels, shown on a seven-segment display.
- A Li-ion setting lets the VE.Bus BMS control it, and it can also interrupt charging between a charger and a Li-ion battery.
- Draws 1.5 mA when on and 0.6 mA when off or in low voltage shutdown.
- Disconnects the load when DC voltage exceeds 16V or 32V, to protect sensitive loads from overvoltage.
- Uses MOSFET switches instead of relays, so there are no sparks.
- Alarm output turns on if voltage stays below the disconnect level for over 12 seconds, so starting the engine will not trigger it.
Specifications
| Part number | BPR000065400 |
| GTIN | 8719076034193 |
| System voltage | 12/24V auto ranging |
| Operating voltage range | 6-35V |
| Max continuous load current | 65A |
| Peak current (during 30 seconds) | 250A |
| Default engage threshold | 12V or 24V |
| Over voltage disconnect | 16V or 32V |
| Current consumption, when on | 1.5 mA |
| Current consumption, when off or low voltage shutdown | 0.6 mA |
| Alarm output delay | 12 seconds |
| Maximum load on alarm output | 50 mA (short circuit proof) |
| Load disconnect delay | 90 seconds (immediate if triggered by the VE.Bus BMS) |
| Load reconnect delay | 30 seconds |
| Operating temperature range | Full load: -40°C to +40°C (up to 60% of nominal load at 50°C) |
| IP rating | Electronics: IP67 (potted); Connections: IP00 |
| Connection | M6 |
| Mounting torque | 5 Nm |
| Weight | 0.5 lbs (0.2 kg) |
| Dimensions (H x W x D) | 1.6 x 1.9 x 4.2 inch (40 x 48 x 106 mm) |
The BatteryProtect is not designed for reverse currents from charging sources.







